No. 49, Jalan TS 6/5,
Taman Industri Subang,
47510 Subang Jaya,
Selangor, Malaysia.
+603-8011 6618
Sceptre Power Sdn Bhd
No. 49, Jalan TS 6/5,
Taman Industri Subang,
47510 Subang Jaya,
Selangor, Malaysia.
No. 49, Jalan TS 6/5,
Taman Industri Subang,
47510 Subang Jaya,
Selangor, Malaysia.
Flange Insulation Sets
TEXSEAL
“TexSeal” gaskets are made with a special O-Ring sealing element inlayed in the face of the gasket. This O-Ring creates a very flexible seal that requires less bolt or stud torque to maintain constant contact with the flanges sealing surface surface.
TexSeal gaskets are available in both F and E styles.
The O-Ring seal and gasket are available in a wide variety of materials.
.jpg)
Type D gaskets are machined from a specified insulating material and are designed to fit ring joint type groove flanges.
BX gaskets are also available.
Available Materials: Hi-Temp G-3, G-7, G-10, G11, Phenolic
A 1/4” thick closed cell neoprene sponge flange protector is recommended to prevent the flanges from shorting out.
.jpg)
Type E gaskets offer complete protection for both flange faces. The gasket centers easily having the same outside diameter as the flange. This prevents foreign matter from accumulating between flange faces and shorting out the flanges
.jpg)
Type E-RTJ combination gaskets are are made with an insulating ring joint gasket and insulating inner and outer rings. This special design gasket offers complete protection for both flange faces. The RTJ gasket provides the seal, while the 1/32'' thick inner and outer barrier rings cover the I.D. to the O.D. This prevents foreign matter from accumulating between flange faces and shorting out the flanges. It is available in most sizes and materials
.jpg)
Type F gaskets are fabricated to fit the raised face portion of the flange face and are designed to center on the inside of the bolt circle.
We recommend that a flange protector made from 1/4” thick closed cell neoprene sponge be used to prevent foreign matter from collecting between the flange faces.
Selections
| Sealing | |
|---|---|
| NS | Nitrile |
| TS | Teflon |
| VS | Viton |
| GS | Graphite |
| QS | Non-Asb |
| Gasket | |
|---|---|
| G10 | G-10 Epoxy/Glass |
| G11 | G-11 Epoxy/Glass |
| HTG-3 | High Temp |
| N | Nitrile Coated Phenolic |
| P | Phenolic |
| Q | Non-Asbestos |
| R | Red Rubber |
| RD | JM 940 (Red Devil) |
| Washers | |
|---|---|
| SW | Single Washer |
| DW | Double Washer |
| Phenolic and Plated Steel Washers are standard | |
|
Other materials available on request are... G10 G11 HTG-3 (Hi-Temp 450°F) TexMica (Hi-Temp 932°F) |
|
| Sleeves |
|---|
| G10 |
| G11 |
| Integral (Minlon) |
| JM 940 (Red Devil) |
| Mylar |
| Nomex |
| Phenolic (Micarta) |
| Polyethylene (Poly) |
| Teflon |